Ever have those pins that you saved at the beginning of Pinterest-time and have always wanted to make? I’ve wanted to make a wooden couch sleeve for a long time — it seems like an easy, practical solution without having side tables everywhere. But our main living room furniture has rounded arms and these wooden couch sleeves definitely seem better suited for a squared off arm.
I knew I would be able to make this fairly inexpensively as long as we had some scrap wood laying around — and luckily we did! I was able to utilize tools that we already had, so this project cost me $0. And with our basement makeover, our furniture downstairs had squared off arms with a lower side table that only serves part of the seating, I thought this would be a perfect addition to our ‘finished-unfinished’ space especially with the natural rustic wood piece.
What You’ll Need:
– Scrap wood
– Table saw
– Satin/Gloss Clear Coat Spray Paint
– Nail gun
1. Determine the length of your main top piece based on your furniture. I decided on 13″ long and kept the original width of the board. You’ll want your sides to be the same length, width of sides can be all equal or shorter.
2. Using a tape measure and straight edge, draw a straight line for your top piece, then cut with table saw. For the sides because my scrap wood was older, I cut the same length and it pretty much split down the middle to make two smaller pieces. I liked the more unfinished, raw edges as I wanted to keep the integrity of the older wood.
3. I then sanded the pieces on both sides and all of the edges. Again, I liked the color of the wood – I just needed to work out a few rough spots and clean it up. After sanding, be sure to wipe down the pieces with a cloth to get rid of extra dust.
4. I then did a top coat with Satin finished spray paint — that I happened to have at the house already. Spray top coats are a little trickier to see full coverage until dry – so for that reason you may need to do a few coats depending on the finish and coverage you want (above picture before spray, bottom after spray). I did two coats on the main top and sides, and one on the underneath part.
5. Once I was content with the top coat it was putting everything into place with the nail gun. I opted NOT to use wood glue for two reasons (1) being lazy (2) we don’t have clamps, so we would’ve nailed in place shortly after gluing like we did for our floating shelf. This was a two person job to ensure the nails went in securely. We put the sides in a bit so they would be snug against the couch, since I opted to keep the top the original width of the wood, avoiding too many cuts.
Pro-tip: I made sure all my cut edges were in the back of my piece, so the original rough edges would be facing out. I also determined my top early on when measuring and cutting pieces.
This is the perfect addition to the space, and it’s sturdy for an afternoon cup of coffee, the remote or a glass of beer watching the game! Although we have a super cute trunk side table in this space, it’s much lower than the couch and chair so it isn’t exactly convenient for ongoing sipping. This couch sleeve is also portable, so it can move around depending on which spot you’re in or who needs it. I love how it turned out and it’s imperfections! Plus — this could also be a sweet Christmas gift for just about anyone.